Machine Information; Technical Specifications - VONROC PH515AC Traducción Del Manual Original

• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
This product is designed as a patio heater for
domestic environments. The heater is intended for
private gardens or other outdoor areas at home.
The heater may not be used to heat an indoor
space, usage as a non-household outdoor space
heater or for the drying of textiles or other mate-
rials. This heater is not equipped with a device to
control the room temperature so do not use this
heater in spaces when they are occupied by per-
sons not capable of leaving the room on their own,
unless constant supervision is provided. The device
is to be used only for its prescribed purpose. Any
other use is deemed to be a case of misuse.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power
Heating element type
Heating time
Wave length
Radiant efficiency
Heating distance
Heating area
Colour temperature
Overheat protection
Electronic soft start
Tip-over safety switch
Ingress protection class
Protection class
Weight
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
WWW.VONROC.COM
PH515AC
220-240 V~
50-60 Hz
1500W
Carbon fibre lamp
3 seconds
3.0-1000 microns
90%
2-3m
2-3m²
1600 K
Yes
Yes
Yes
IP44
Class I
3.8 kg
1. Handle
2. Power cable
3. On/off switch
4. Heater
5. Protective grill
3. OPERATION
Place the device on a level and steady
surface.
Place the device with a minimum distance
of 1 meter to any object, wall or ceiling.
Switching on/off (Fig. A)
• To turn the heater on, put the mains cable in the
mains power supply and put the switch (3) on
the heater to the On position.
• To turn the heater off, put to the switch (3) on
the heater to the Off position
Tip­over safety switch (Fig. A, B)
This heater is fitted with a tip-over safety switch. In
the event that the heater falls over (see figure B),
the heater automatically shuts off. Please note that
when the heater is returned to its upright positi-
on, it does not resume its operating immediately.
First switch it off (read 'switching on/off'), remove
the plug from the socket and check the heater for
damage. In case of damage or malfunctioning do
not use but offer for checking / repair. If there is no
damage, you can simply switch the heater on again
(read 'switching on/off').
Carrying handle (Fig. A)
The heater is fitted with a carrying handle (1) for
easy and convenient moving of the device. Do not
move the heater or use the carrying handle when it
is turned on.
4. MAINTENANCE
Always make sure that the machine is not
connected to the mains electricity when you
carry out any maintenance of the mechanism.
CAUTION: Risk of Electric Shock. DO NOT
open or try to repair the heater yourself.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
EN
5