Duronic PS132 Instrucciones De Uso página 10

1. Carefully place the PS132 shredder on a dry, flat, level surface.
2. Ensure that the waste bin is properly in place inside the machine.
3. Be careful not to place your fingers near the cutter blades.
4. Plug the power cable into any standard 220-240-Volt AC mains outlet / plug
socket which should be located near the shredder and should be easily
accessible.
5. Place the switch into the AUTO position.
The power switch is located on the top of the shredder. The switch has three
settings: AUTO, OFF, Reverse/REV.
When AUTO is selected, the shredding process is started automatically by
inserting paper into the feed opening. The shredder will also stop automatically
when the paper has completed its travel through the feed opening.
REV mode is used to assist in the removal of a paper jam. This reverses the
shredding process before the cycle finished, thus clearing the cutting blades.
Select the OFF mode when emptying the waste bin or when the shredder is not in
use for a long period of time.
You are now ready to start shredding.
Operation
Setup
10