Alpina YL-B12-5A Manual De Instrucciones página 4

•
This heater is hot when in use. To avoid burns and personal injury, do not
let bare skin touch hot surfaces. If provided, use handles when moving the
product.
•
Be sure that no other appliances are in use on the same electrical circuit
as your product as an overload can occur.
•
This heater is filled with a precise quantity of special oil.
•
Repair requiring opening of the oil container are only to be made by the
manufacturer or his service agent who should be contacted if there is an
oil leakage.
•
Regulations concerning the disposal of oil when scrapping the appliance
have to be followed.
•
The heater should not be used in a room, of which the floor area is less
than 5 M .
2
•
The cord shouldn't be placed nearby the hot surface of the appliance.
•
NOTE: It is normal when the heaters are turned on for the first time or
when they are turned on after having not been used for a long period of
time the heaters may have noise inside, This will disappear when the
heater has been on a short while.
OPERATION OF THE RADIATOR
NOTE: When the radiator is turned on for the first time or after having not
been used for a long time, it may emit a smell and fumes. This will cease
when the radiator has been on for a short while.
1) Choose a suitable location for the radiator, taking into account the safety
instructions above.
2) Insert the plug of the radiator into a suitable power socket.
3) Turn the thermostat knob fully in a clockwise direction to the maximum
setting.
4) Turn on the heating element by means of the rocker switch on the side
panel. When the heating element is on, the power switch will illuminate.
5) When the desired room temperature has been reached, the thermostat
knob should be turned slowly anticlockwise (counterclockwise) until the
thermostat is heard to click off and the light on the power switch is seen
to go out. After that, the radiator will keep the air in the room at the set
temperature by switching on and off automatically.
CLEANING THE RADIATOR
1) Always unplug the radiator from the power socket and allow it to cool
down before cleaning it.
2) Clean the outside of the radiator by wiping with a damp cloth and buffing
with a dry cloth. Do not use any detergents or anything abrasive, and do
not allow any water to enter the radiator.
MAINTENANCE