HomeMatic IP HmIP-eTRV-B-2 Manual De Instalacion Y Uso página 39

You can connect the device either to the Access Point or to the
Homematic Central Control Unit CCU3. For detailed information,
please refer to the Homematic IP User Guide, available for download
in the download area of www.homematic-ip.com.
To integrate the device into your system and to enable control via the free
Homematic IP app, you must teach-in the device to your Homematic IP
Access Point first.
To teach-in the device, please proceed as follows:
• Open the Homematic IP app on your smartphone.
• Select the menu item "Teach-in device".
Open the battery compartment (B) by pulling the battery
•
compartment down (see figure 3).
• Remove the insulation strip from the battery compartment.
Pairing mode remains activated for 3 minutes (see figure 5).
You can manually start the teach-in mode for another 3 minutes by
pressing the system button (D) briefly (see figure 5).
• Your device will automatically appear in the Homematic IP app.
• To confirm, please enter the last four digits of the device number
(SGTIN) in your app or scan the QR code. Therefore, please see
the sticker supplied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED (D) lights up green. The
device is now ready for use.
• If the LED lights up red, please try again.
• In the app, give the device a name and allocate it to a room.
Start-up
39