Direct Mounting - Eiko VERT Instrucciones De Instalación

SLIP FITTER MOUNTING WIRING:
ALWAYS TURN OFF THE POWER SUPPLY FROM MAIN CIRCUIT BREAKER FIRST!
1. LOOSEN THE FOUR BOLTS ON AM BRACKET, CONNECT THE WIRES CORRECTLY, AND PULL THE WIRES
INTO THE POLES. (FIGURE 3)
2. PLACE THE BRACKET INTO THE POLE AND LOCK THE FOUR BOLTS. (FIGURE 4)
• NOTICE: ADJUSTABLE ANGLE IS 0-90°. (FIGURE 3)
• PIPE DIAMETER RANGE IS 1½" to 2⅜"
3
FIXTURE
Fits Pipe Diameter:
1½" to 2⅜"

DIRECT MOUNTING:

ALWAYS TURN OFF THE POWER SUPPLY FROM MAIN CIRCUIT BREAKER FIRST!
1. REMOVE THE BRACKET MOUNTING SCREWS ON THE FIXTURE, OPEN THE SIDE LID OF BRACKET AND
RUN THE WIRES THROUGH THE BRACKET. (FIGURE 5)
2. INSTALL THE BRACKET ON THE FIXTURE, THEN COVER THE SIDE LID AND TIGHTEN IT. (FIGURE 6)
5
EiKO Global | 18000 W 105th, Olathe, KS 66061 | (P) 1-800-852-2217
EiKO Canada | 81 King St, Barrie, Ontario L4N 6B5 | (P) 1-705-721-5189
AM BRACKET
LOCKING BOLT
WIRE
SUPPORT
4
ADJUSTING BOLT
6
FIXTURE AM BRACKET
SUPPORT
eiko.com