DURAVIT Sensor 1 Instrucciones De Montaje Y Uso página 7

These instructions are part of the Duravit
product and must be read carefully and kept
available at all times.
Target readership and qualifications
The product may only be installed by a
qualified plumber.
Explanation of the key words and symbols
NOTICE
Addresses practices not related to
physical injury.
Link to the mounting instructions
in this section
Prompt for inspection
(e.g. for scratches)
Prompt to inspect
for leaks and leak-tightness
Prompt to wear
gloves
Disposal
• Do not dispose of the product
in household waste. Products
with this symbol must be
disposed of in accordance with
the WEEE Directive through
local collection points for waste
electrical equipment.
Technical data
Operating pressure
Recommended
Test pressure
Pressure difference K/W max. 0.1 MPa
1 MPa = 10 bar = 145 PSI
Hot water temperature
Operating temperature
Safety instructions
Cut and crushing injuries
> Wear gloves when installing the product.
Product and/or property damage
> Observe the local installation regulations
and any country-specific standards at all
times.
> Equalise pressure differences between cold
and hot water connections.
> Observe the manufacturer's instructions for
installation with continuous flow heaters.
Avoid product damage
> Use the product only with the power supply
supplied.
> Insert the batteries with the correct
polarity.
> Remove rechargeable batteries from the
device before recharging.
> Do not recharge non-rechargeable
batteries.
> Do not short-circuit the power supply
terminals.
max. 0.8 MPa
0.3 – 0.5 MPa
1.6 MPa
max. 60 °C
4 – 40 °C
7
MAL_58902/22.06.1