Troubleshooting; Error Codes And Flashing Sequences - HomeMatic IP HmIP-WUA Manual De Instalacion Y Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 58

Troubleshooting

Select the menu item "Teach-in device".
After the main fuse is reset, the actuator's teach-in mode remains
activated for 3 minutes (see fig. 12).
You can manually start the teach-in mode for another 3 minutes by
pressing the system button (A) briefly (see fig. 12).
Your device will automatically appear in the Homematic IP app.
To confirm, enter the last four digits of the device number (SG-
TIN) in your app or scan the QR code. The device number can be
found on the sticker supplied or attached to the device.
Wait until teach-in is completed.
If connecting was successful, the LED (A) lights up green. The
device is now ready for use.
If the LED lights up red, please try again.
Select the desired solution for your device.
In the app, give the device a name and allocate it to a room.
6
Troubleshooting
6.1

Error codes and flashing sequences

Flashing code
Short orange
flashing
1x long green
flash
Short orange
flashing (every
10 s)
6x long red
flashes
36
Meaning
Radio transmission/
attempting to transmit/
data transmission
Transmission confirmed You can continue opera-
Teach-in mode active
Device defective
Solution
Wait until the transmission
is completed.
tion.
Please enter the last four
numbers of the device
serial number to confirm
(see „5.3 Teaching-in" on
page 35).
Please see your app for
error message or contact
your retailer.

Publicidad

Tabla de contenido
loading

Tabla de contenido