EN
36
Start point
Pass the wire ropes through the screws on the bracket. Adjust the length of the
ropes to the marking line and fix them with the securing pins.
5
Measure the length of the
wire ropes (L) and refer to
the dimension given under
'Dimensions': L = X-Y-26 (mm).
Mark a line on the wire ropes.
Note: The extractor hood
should be installed at a height
of 65-80 cm (gas) or 60-80 cm
(electric cooker) above the
starting point of the hob. If a
larger minimum distance for
cooker hoods is specified in the
operating instructions of the
cooker, this minimum distance
and not the one mentioned
above must be observed.
6
Wire rope
Locking pin
M4 screw