Stop Ruler (Special Accessories); Installation Stop Ruler - Mafell MAF02255/b Manual De Instrucciones Original

6) on the rod holder 4 until the stop rail 2 rests
parallel against the saw blade.
•
Unfasten the stop plate 11 (Fig. 3) at the
underside of the guide rod with a screwdriver.
•
Push the stop plate 11 (Fig. 3) up to the rod
holder and fasten it with the two cylinder head
screws 12.
For cross and angle cuts on the pit saw, the multi-
function stop is conveniently attached to the left
longitudinal side of the table. In this position, the 0° or
90° mark is indicated on the angle scale when making
right angled cuts.
To make angle cuts, loosen the handle 6 (Fig. 1) on
the upper side and swivel the stop rail 2 to the desired
position according to the angle scale. A detent can be
activated by means of the recesses 17 (Fig. 3) on the
angle stop. Retighten the handle afterwards.
The detent can be activated and deactivated by means
of the detent button 14. This is done by turning the
detent button by 90° each time.
For angle cuts, both stop rails 2 and 3 can be used as
workpiece stops at any time. This means that right and
left mitres on profiles are also possible without
adjustment.
The stop rail should always reach as close as possible
to the cutting plane in order to achieve better cutting
quality. It is therefore notched at its ends, so that the
upper saw guard can be moved close enough even
when cutting thin workpieces.
By moving the multi-function stop along the table, the
stop can additionally be adjusted so that an optimum
working method is achieved depending on the
respective workpiece dimensions.
6

Stop ruler (special accessories)

The 1 metre long stop ruler 15 (Fig. 5) replaces the
stop rail 2 (Fig. 1) and thus enables trimming according
to scale up to 1 metre. The supplied trimming cover 16
(Fig. 5) can be used as a length stop and adjusted
according to scale.
With the telescopic rod that is available as an optional
accessory, the trimming range can be extended to
approx. 1.80 m. The support plate that is included in
the delivery serves as workpiece support.

6.1 Installation stop ruler

•
After removing the stop rail 2 (Fig. 1), first mount
the clamping nut 20 (Fig. 4) to the angle stop
using the cylinder-head screw 21. The clamping
nut is additionally required to absorb the
longitudinal forces occurring when using the
trimming cover.
•
Swivel the angle stop to 45° for installation.
•
Slide the stop ruler 15 onto the angle stop until
the rear edge of the cut-out is in contact with the
short stop
This ensures that the scale in the stop ruler
matches the saw blade at every angle setting.
-11-
bar (see Fig. 5).