Grandstream GHP610/W Guía De Instalación Rápida página 5

INSTALLING SPEED DIAL LABEL:
1. Handwrite or print the names on the dedicated space on
the paper label.
2. Place the paper label in the groove of the phone.
3. Bend the plastic film so that the protruding points on the
left and right sides can snap into the grooves.
Note: To remove the film, use a nail or thin card to move
the slit on one side of the film to bend it and then take it out.
INSTALLING MPK LABEL:
CONNECTING THE PHONE:
To set up the phone, follow the steps below:
1. Plug in the phone cord to the handset RJ11 port and then
connect it to the base.
2. Connect the LAN port of the phone to the RJ45 socket
of a hub/switch or a router (LAN side of the router) using
the Ethernet cable. This step can be skipped if using
GHP610W & GHP611W with Wi-Fi.
~ 5 ~
Scan the QR code to
watch the speed dial
installation and configu-
ration video guide
1. Remove the MAC address
sticker from the front of the
handset.
2. Remove the release paper
from the back of the MPK
label.
3. Stick the MPK label on the
indicated area. Please refer
to the illustration on the left.
3. Power up the phone:
• For GHP610W & GHP611W: Connect the 12V DC
output plug to the power jack on the phone; plug the
power adapter into an electrical outlet.
• For GHP610 & GHP611: A PoE switch must be used
in step 2.
Note: The GHP610W/GHP611W is preconfigured to
connect to a default SSID named "wp_master" with
password (WPA/WPA2 PSK) "wp!987@dmin". Users can
also modify these settings from the phone's web UI.
PHONE CONFIGURATION:
1. Ensure your phone is powered up and connected to the
Internet.
2. Locate the MAC address on the bottom of the device or
on the package.
3. From a computer connected to the same network
as the GHP61X, type in the following address using
the GHP61X's MAC address on your browser:
https://<mac>.local
Example: https://c074adffffff.local
Note: The user can also dial **47# and the current IP
address will be announced by the IVR.
4. Enter the admin username and password to access the
configuration menu. (The factory default username is
"admin" and the default random password can be found
on the sticker at the back of the unit).
Refer to online documents and FAQ for more detailed
information: https://www.grandstream.com/our-products
~ 6 ~