While Operating - VITO PRO-POWER VIBCBBSFL20 Manual De Instrucciones

▪ Check that all screws are properly tightened. Regular
inspection is important to ensure safety issues and
the performance of the power tool;
▪ After the accessories assembly and before using the
power tool, test it at full speed with no load for a
while. Check for moving parts misalignment or any
other condition that may affect the combi drill
operation. Check that all moving parts run smoothly,
without abnormal noises;
▪ Check that the safety devices are in perfect condition
and function properly. Never use the power tool if
the safety devices are missing, inhibited, damaged or
worn out;
▪ If the ON/OFF switch is damaged or does not allow
the operation of the tool to be controlled, it must be
repaired or replaced in order to prevent any
accidental start.
Make all adjustments and work necessary for the
correct assembly of the combi drill. If you have any
questions or difficulties,
distributor.

While operating

Keep third parties away from the power tool's
area of operation. Never work while animals or
people, especially children, are in the danger zone.
Keep the work area clean, organized and well lit (250 to
300 lux), thus decreasing the risk of accidents.
Always wear personal protective equipment and
clothing. Wearing a visor or goggles, dust mask, hearing
protection, anti-slip safety shoes, long-sleeved clothing,
gloves and helmet properly reduces the risk of injury.
Clothing worn during the appliance operation must be
adequate, tight and closed, for example, a work boiler
suit. Do not wear loose clothing or jewelry. Keep hair,
clothing and gloves away from moving parts.
The control and safety devices installed must not be
removed or inhibited.
contact your official
To avoid accidents, you should also take into
consideration the
procedures:
▪ The rotating accessories speed of the combi drill
must be at least equal to the maximum speed stated
in the technical specifications;
▪ When operating the combi drill, place yourself in a
stable position and always keep your balance. Hold
the appliance firmly to ensure continuous operation
and withstand unexpected situations, such as
kickback;
▪ The kickback is a sudden reaction that happens when
the power tool is switched on and the rotating
accessory gets jammed. The rotating accessory
kickback forces the power tool to rotate in the
opposite direction to the rotation of the accessory;
▪ The kickback occurs due to an incorrect use of the
power tool or due to an improper working procedure
which can cause serious injuries to the user. Loss of
control can result in serious injury. To avoid the
kickback, the following precautions must be
considered:
- Place the rotating accessory in the correct position
and keep it securely locked in place;
- Do not position your body in the area where power
tool will move if kickback occurs;
▪ Never put your hands near the rotating attachment.
Keep your hands away from the rotating parts;
▪ When the rotating accessory gets jammed, switch off
the tool immediately;
▪ To avoid displacements or projections use a fixing
device or a bench vice to ensure a safe performance;
Place/maintain the workpiece in a correct and stable
position;
▪ Never put the tool down before the rotating
accessory has completely stopped. The rotating
accessory may grab the surface, causing you to lose
control of the power tool;
following precautions and
25