Swann SWIFI-4KFLOCAM-US Guia De Inicio Rapido página 7

The floodlight camera unit is designed to be mounted on a standard wiring junction box and requires
connection to a 100-240VAC power supply. For optimum results, install the unit at least 8 feet (2.4m)
above the ground.
NOTE: BEFORE MOUNTING, ENSURE THE INSTALLATION LOCATION IS WITHIN RANGE OF YOUR CURRENT WI-FI SIGNAL.
SEE "GETTING STARTED" ON PAGES 4-5 FOR INFORMATION ON HOW TO CHECK WI-FI COVERAGE.
IMPORTANT! TURN POWER OFF AT CIRCUIT BREAKER OR FUSE BOX.
CAUTION: BEFORE HANDLING ANY WIRING, USE A CIRCUIT TESTER TO CONFIRM THAT POWER IS OFF.
When installing the unit, refer to the installation diagram on the previous page.
1 If you're replacing an old floodlight unit, disassemble it along with any existing mounting
bracket from the junction box and disconnect the wire connections.
2
The floodlight camera unit's mounting bracket comes pre-assembled. Remove both the screw
cap and the mounting bracket screw
3 Fix the mounting strap (supplied) to the junction box using two mounting screws
of different screw types supplied) that best fit your junction box. The side of the mounting strap
marked "FRONT" should be facing out.
4
Connect the junction box and floodlight wires using the wire nuts (supplied). Use the color code
of the wires to match correct connections, as shown in the installation diagram.
5 Once the wires are connected, carefully tuck them into the junction box.
INSTALLATION INSTRUCTIONS
A
to separate the mounting bracket.
(three sets
B
(continued next page)
EN
7