Husky MIG140 Guía De Uso Y Cuidado página 11

Operation Instruction (continued)
4
Setting Up the Welding Wire
□
Release the drive roll pressure arm (11) by lifting up the
pressure arm adjustment knob (10).
□ Rotate the drive roll knob (13) counterclockwise to
remove it (See Figure 2
□
Check your drive roll (14) size. Ensure it matches with
your welding wire size.
NOTE: Drive roll (14) has two grooves and each groove
has a different size. Make sure you are using the right
size.
□
Place the drive roll knob (13) back and rotate clockwise to
tighten it.
□
Before inserting your wire into the wire feeder, ensure
your wire end is straight. Cut the bent end with wire
cutter if necessary.
□
Feed your wire into the wire inlet guide tube (12) of the
wire feeder and line the wire up with the groove of the
drive roll. Push the wire across the inner drive roll groove
into the other side of the wire feeder.
□
Pull the pressure arm adjustment knob (10) back and lock
it by pushing the drive roll pressure arm (11) down.
□
Remove the nozzle from the end of the MIG/ ux core MIG
gun.
NOTE: Metal nozzle is for MIG gun; non-metal nozzle is for
ux core MIG gun.
□
Remove the contact tip from the tip of the gun by
unscrewing in counterclockwise direction.
□
Plug the welder into power source and switch the ON/OFF
switch (O) to ON. Ensure you are not pointing the MIG/ ux
core MIG gun to yourself and any other bystanders.
□
Press the trigger on the MIG/ ux core MIG gun. Feed the
wire continuously until at least one inch of the wire
extends out of the gun.
□
Check if the drive roll is feeding the wire properly. If the
drive roll is slipping on the wire, increase pressure on the
pressure arm adjustment.
□
Check the contact tip and ensure it matches the welding
wire. Install the contact tip back to the MIG/ ux core MIG
gun.
□
Install the nozzle back to the gun.
□
Cut off the over-extended wire that sticks out of the ux
core gun if needed.
. and Figure 3. ).
10
12
.
Figure 3 (i) Locked Wire Feeder, (ii) Released Drive Roll
Pressure Arm, (iii) Removed Drive Roll Knob
11
Please contact 1-888-43-HUSKY for further assistance.
Figure 2. ire Feeder W
i
ii
14
13
iii
HUSKYTOOLS.COM
11
13