Husky MIG140 Guía De Uso Y Cuidado página 12

Operation Instruction (continued)
5
Setting Up for MIG/Flux Core Welding
□
Check your welding wire type.
Flux core wire: Connect the ground clamp cable to positive
(+) DINSE socket (M) and electrode polarity jumper (H) to
the negative (-) DINSE socket (L).
Solid core wire: Connect the ground clamp cable to the
negative (-) DINSE socket (L) and electrode polarity jumper
(H) to the positive (+) DINSE socket (M).
□
For flux core wire, no shielding gas is needed.
□
For solid core wire, follow instruction "Connecting the Gas
Cylinder." Connect one side of gas hose to gas regulator on
the gas cylinder and the other side to the gas input (N) at
the back of welder.
□
Ensure your workpiece is clean and dry and the ground
clamp has a good connection to the workpiece.
□
Connect your MIG/flux core MIG gun to the gun cable
socket (G) and control socket (I).
□
Open the side panel. Load the wire spool and feed the wire
into the wire feeder. For detailed instructions please see
"Installing the Wire Spool" and "Setting Up the Welding
Wire."
□
Ensure you are not pointing the MIG/flux core MIG gun to
yourself and any other bystanders. Switch the ON/OFF
power switch (O) to ON at the back of the welder.
□
Follow instructions "Setting Up the Welding Wire," and feed
the welding wire into the wire feeder and flux core gun.
Press the MIG/flux core MIG gun trigger to load welding
wire through the flux core gun.
□
Adjust the wire feed speed adjustment knob (E) to set your
wire feed speed.
□
Adjust the voltage adjustment knob (D) to set your welding
voltage.
□
Hold the MIG/flux core MIG gun to the workpiece and press
the gun trigger. The weld arc can be initiated by touching
the weld wire to the workpiece.
12