Installing The Wire Spool - Husky MIG140 Guía De Uso Y Cuidado

Operation Instruction (continued)
3

Installing the Wire Spool

□
Make sure ON/OFF power switch (O) is OFF and unplug the
welder before proceeding.
□ Open the welder case by pushing the buckle located on the side
panel.
□
Unscrew the wing nut (1), and remove key washers (2), spring
(3) and spool cap (4).
□
For 10 lb wire spool: Keep the spool adapter (6) on the wire
spool spindle in a manner as shown on the upper diagram.
□
For 2 lb wire spool: Remove the spool adapter (6) from the wire
spool spindle.
□
For 10 lb wire spool: Install the wire spool (5) on the wire spool
adapter and match the hole on the wire spool with the "stick
out" (7) of the spool adapter.
□
For 2 lb wire spool: Install the wire spool on the wire spool
spindle.
NOTE: After installation, ensure the wire spool rotating in a
counterclockwise direction when operating.
□ For 10 lb wire spool: Place the spool cap (4), spring (3), key
washers (2) and wing nut (1) back.
For 2 lb wire spool: Place the spring (3), key washers (2) and
□
wing nut (1) back.
□
To make sure wire spool can spin properly, avoid
overtightening or insuf cient tightening of the spool cap.
Overtightening may cause inconsistent wire feeding while
insuf cient tightening will cause uncontrolled wire feeding.
□
Next, please check the "Setting Up the Welding Wire" to feed
the welding wire through MIG gun.
Figure 1. 10 lb Wire Spool Assembly (Top) and 2 lb
Wire Spool Assembly (Bottom)
10
1
2
3
2
4
5
6
7
1
2
3
2
5