The Shutdown With Remote Control - Power Products GENERGY EZCARAY Instrucciones De Uso

5 On the remote control, press the START button for a few seconds. On the
control panel, PILOT LAMP flashes and the first attempt of starting will be
done. If the generator does not start at the first attempt, fully automatic, more
will be done up to a maximum of 6 attempts.
Information: OPD Function (Output power delayed). Up to 20 seconds after the
starting, the generator does not generate electricity in the socket. This ensures
that the generator starts without supplying power to the connected equipment.
Information: If the LED of the remote control device does not turn on or is weak,
replace the battery.

7.2 The shutdown with remote control.

To stop the generator just press STOP on the remote control. If you do not use the
generator for some time, remember to turn the DIAL to the OFF position.
NOTE: Never, do not stop the automatic sequence of the starting or of the
shutdown. Only in case of an emergency. The automatic sequence has to be
finished, before to send a new signal from the remote control device.
63