Genergy Sleep Function; Synchronize New Remote Control Device; Restart The Remote Control System Completely - Power Products GENERGY EZCARAY Instrucciones De Uso

7.3 GENERGY SLEEP function.

When we turn the starting button (DIAL) to the ON position, the remote receiver
waits for a signal from the remote control device. This remote receiver has a small
electric consumption, which is supplied by the battery of the generator. The battery
can discharge if the DIAL remains in the ON position without run (standby).
To avoid the discharge of the battery, the generator has installed an automatic
disconnection system of the remote receiver. After 12 hours of the last running, the
receiver will be automatically disconnected.
Now, for the remote control by a new remote control device, it is necessary to
reset the remote receiver. On the control panel press the button RE-START
RECEIVER.

7.4 Synchronize new remote control device.

1 On the control panel turn the DIAL to the ON position.
2 On the control panel press the button RE-START RECEIVER.
3 On the control panel keep pressing the RESET button until the PILOT
LAMP lights up.
4 On the remote control device press the button START. And on the
generator, the PILOT LAMP flashes for only one time, then keep pressing
the RESET button again until the PILOT LAMP lights out to quit out. Then
the remote control device has been synchronized correctly.

7.5 Restart the remote control system completely.

Information: Apply only if the remote start function does not work or works
abnormally.
1 On the control panel turn the DIAL to the ON position.
2 On the control panel press the button RE-START RECEIVER.
3 On the control panel keep pressing the RESET button until the PILOT
LAMP lights up.
4 On the remote control device press the button STOP, and the PILOT LAMP
on the generator flashes for only one time to delete all synchronized remote
control devices.
5 To synchronize again a remote control device, see point 4 of the chapter
7.4.
NOTE: Only two remote control devices are allowed to be synchronized with
the remote receiver. So, if you want to synchronize new remote control devices
(loss or damage of the old ones), you have to reset the old synchronized remote
control devices.
64