Glowforge Pro Guia Del Usuario página 30

Snap in the Printer Head
Never connect or disconnect the printer head while the Glowforge is plugged in or you might
break something.
Position the Laser Arm and Metal Plate
Gently slide the metal plate on the laser arm
all the way to the right, then push the arm to
the back of the unit.
Carefully Pick Up the Printer Head
Do not touch any part of the printer head that
is not flat black metal. Be especially careful
of the yellow window on the side of the head.
R​ e move the printer head from the white foam
tray and remove the orange foam cylinder
from inside the head.
Pick Up the Wire Ribbon
Holding only the finished black surfaces of
the printer head, pick up the printer head
and wire ribbon as shown.
Copyright Glowforge, Inc. 2019
30