Glowforge Pro Guia Del Usuario página 31

Slide the Ribbon Into the Head
Make sure the tab on the wire ribbon is facing up.
Slide the ribbon into the head until it clicks.
Attach the head
As shown, lower the printer head over the metal plate so that it rests next to the two round
posts. Then push it gently away from you – you'll feel a "click" as magnets pull the printer
head until it sits snugly atop the metal plate.
Make sure the head slides freely and move it to the center
● Using both hands, gently move the laser arm to the center of the bed.
● Gently slide the head all the way to the left, then right.
Copyright Glowforge, Inc. 2019
31