Placing The Receiver - Trust SWITCH-IN START-LINE ACM-2300-HC Manual Del Usuario

EN
ACM-2300-HC BUILD-IN SWITCH
The LED on the module will blink fast in order to confirm that the code is stored. The receiver can
store up to 32 different transmitter codes in its memory. The memory is retained when the receiver is
installed elsewhere or when there is a power failure.
10. Wireless control
Send with the transmitter an ON signal to turn the light on wirelessly.
Send with the transmitter an OFF signal to turn the light off wirelessly.
The existing wall switches which are used to control the connected lighting can still be used.
11. Set the desired switch-off time
Set the switch-off time to the desired position with a flathead screwdriver. The switch-off time can
also be changed after the switch is paired to a Trust Smart Home transmitter.
0m: No OFF signal is sent automatically.
1m, 10m, 1h and 4h: An OFF signal is automatically sent after 1 minute, 10 minutes, 1 hour or 4 hours.

12. Placing the receiver

Place the receiver in the ceiling box. Mount the lights back in place.
Make sure that you can always reach the receiver, for example, to reset it, or to register a new
transmitter.
Make sure no stripped parts of wires touch each other.
10