Hama Nano Instrucciones De Uso página 9

Note
• Do not move the remote controls during the learning
process.
• Make sure that the room lighting is not uorescent
tubes or energy-saving lamps, as these could cause
interference and thus hinder the learning process.
• The distance between the two remote controls and the
nearest light source should be at least 1 metre.
• In learning mode, each button can only be assigned
one function. A new function overwrites the function
previously taught on this button.
• Press the Setup button to end the learning function.
• Except for the Setup button, all button can be assigned
a taught-in function.
7.2 Activating the learning function / transferring the
button function
1. Press and hold the Setup button for approx. 3 seconds
until the LED lights up to start Setup mode.
2. To teach a command in TV mode, enter the code 9 8 0 0
0 or 9 8 0 0 1 for STB mode.
3. Press the key of the NANO FB to which you want to teach
a new function. The LED ashes 2x and then lights up
permanently. If no button is pressed within 15 seconds,
the LED ashes 6 times and the learning function is
terminated.
4. Now press the button on the original remote control
whose function you want to transfer.
If the LED goes out brie y and then lights up again
permanently, the function has been successfully taught.
If the LED ashes 6 times quickly, the transfer has failed.
Check the position of the two remote controls and make
sure the batteries are full.If no command is received
within 35 seconds, the LED ashes 6 times and the
learning function is terminated.
5. To teach more buttons, repeat steps 3 and 4.
6. After you have transferred all the desired functions, press
the SETUP button to save all the taught-in functions and
exit Learning mode.
Note
When changing the batteries of the universal remote
control, the functions of the taught-in buttons are
retained.
6
7.3 Deleting taught functions
7.3.1 Deleting a taught function
1. Press and hold the Setup button for approx. 3 seconds
until the LED lights up permanently to start Setup mode.
2. Enter the code 98100 for TV mode or 98101 for STB
mode. The LED ashes once.
3. Press the button of the NANO FB whose taught-in
function is to be deleted.
4. The LED ashes once, the taught-in function is deleted
and has been replaced by the function of the factory
setting.
5. To delete more buttons, repeat step 3.
6. To exit the menu, press the Setup button.
7.3.2 Deleting all taught functions
1. Press and hold the Setup button for approx. 3 seconds
until the LED lights up permanently to start Setup mode.
2. Enter the code 98200 to delete all taught-in buttons in
TV mode or 98201 to delete all taught-in buttons in STB
mode.
3. The LED ashes 2 x, all taught-in functions are deleted
and are replaced by the functions of the factory setting.
8. Restoring factory settings
1. Press and hold the Setup button for approx. 3 seconds
until the LED lights up permanently to start Setup mode.
2. Enter the number 99999.
3. All settings and taught-in functions are deleted and are
replaced by the functions of the factory setting.