Tabla de contenido
Publicidad
Step 3
Separate the EXTENSION SLIDES (6) from the EXTENSION RAILS (5) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (5) to the UPRIGHT (A) and RIGHT END (B). Use six BLACK 1/2" FLAT
å
HEAD SCREWS (15) through the holes shown in the enlarged diagram.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
6
Push the black lever down and pull the SLIDE from the RAIL.
Open end
425773
BLACK 1/2" FLAT HEAD SCREW
(6 used in this step)
A
www.sauder.com/service
15
5
B
Open end
Page 9
Publicidad
Tabla de contenido
