Troubleshooting - Scheppach HM305SL Traducción Del Manual De Instrucciones Original

• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards)
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.

15. Troubleshooting

Fault
Motor does not work
The engine runs slowly and
does not reach the operating
speed.
Engine producing excessive
noise.
The engine does not reach full
power.
Motor overheats easily.
Saw cut is rough or wavy.
Workpiece pulls away and/or
splinters.
38 | GB
Possible cause
Engine, cable or connector defective,
mains fuses blown.
Voltage too low, coils damaged, capacitor
burnt.
Coils damaged, motor defective.
Circuits in the network are overloaded
(lamps, other motors, etc.).
Overloading of the motor, insufficient
cooling of the motor.
Saw blade dull, tooth shape not
appropriate for the material thickness.
Excessive cutting pressure and/or saw
blade not suitable for use.
www.scheppach.com
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Remedy
Arrange for inspection of the machine
by a specialist.
Never repair the motor yourself.
Danger!
Check mains fuses and replace as
necessary
Have an electrician check the voltage.
Arrange for inspection of the motor by
a specialist. Arrange for replacement
of the capacitor by a specialist.
Arrange for inspection of the motor by
a specialist.
Do not use any other equipment or
engines on the same circuit.
Avoid overloading the motor while
cutting, remove dust from the motor
in order to ensure optimal cooling of
the motor.
Resharpen saw blade and/or use
suitable saw blade.
Insert suitable saw blade.