Kinderkraft LUNKY XL Manual De Instrucciones página 18

•
Do not leave anything in the cot or place the cot close to another product, which
could provide a foothold or present a danger of suffocation or strangulation, e.g.
strings, blind/curtain cords. Another products should be placed either tight to
any wall or have a gap of 300 mm between the wall and the side of the bed;
•
Do not use more than one mattress in the cot.
•
The lowest position of the base is the safest. When a child starts to sit down
without the assistance – use only this level.
•
Thickness of the mattress shall be such that the internal height (measured from
the top of mattress to the upper edge of the cot frame) was at least 500 mm in
the lowest position of the cot base and at least 200 mm in the highest position of
the cot base.
•
Maximum thickness of the mattress: 10 cm.
•
Mattress should have size 140 x 70 cm. Length and width shall be that there shall
be no gap more than 30 mm between the mattress and the sides and ends.
•
All assembly elements and fittings should always be tightened properly and
checked regularly and retightened as necessary.
•
Cot with high sides: To prevent injury from falls, if the child is able to climb out of
the cot, the cot shall no longer be used for that child.
•
The bed is intended for children from birth to 4 years of age. Note! The sofa-bed
function of the baby cot is intended for children from 18 months to 4 years of age.
•
For transport or storage it is possible to disconnect the main parts of the cot.
1. List of cot components - page 5
1 Front (x2)
2 Side wall (x2)
3 Bottom
4 Side panel
5 Left leg (x2)
6 Right leg (x2)
2. Cot assembly:
The installation should take place on a soft surface that will not damage the surface of the
elements. Installation should be carried out by two people. Start assembling the cot by
connecting the element (1) and legs (5,6) with the confirmat (D) and the Allen key (F) included
in the set (fig. I). Repeat the same operation on the second element (1). Connect the resulting
elements to the bottom (3) with the mounting kit (B) + (E) and Allen key (fig. II). ATTENTION:
The cot has a 3-step bottom height adjustment. Connect the side (2) to the structure assembled
in the previous steps by screwing it in with screws (C) and an Allen key (fig. IIIa). Repeat the same
A Screw M6 x 75
B Screw M6x55 (x7)
C Screw M6x42 (x8)
D Confirmat 7 x 40 (x8)
E Wheel nut M6 x 15 (x8)
F Allen key
18