Suspended Assembly - Busch+Müller IQ-X E Instrucciones De Uso

6.3 Suspended assembly

ATTENTION: If the headlight
turn it or place it upside down. Other road users would be dazzled!
!
In order to align the headlight correctly in a suspended position, loosen the plastic ring around the
headlight and turn it by 180°. For this purpose, detach the headlight
1
bracket 2 first and then slightly spread the circumferential plastic ring and move the ring around the
headlight 1 by 180°.
WARNING Make sure that the cable outlets on the headlight
is the only way to ensure that the light pattern of the headight
water penetration in the best possible way.
NOTICE The headlight
outlet pointing in exactly the same direction) or suspended and rotated by 180° (Busch + Müller bracket
2 and the cable outlet pointing in exactly the opposite direction). Otherwise, there is a risk that the
headlight 1 might adjust all by itself.
For suspended assembly, the reflector
tor elsewhere parallel to the road at a height between 400 and 1,200 mm.
3
24
1 is to be mounted in a suspended position, please ensure to not simply
must be mounted either upright (Busch + Müller bracket
1
must not be mounted „overhead". Please mount the the reflec-
3
from the Busch + Müller
1
always point straight down. This
1
1 is ideally aligned and protected from
and the cable
2