Troubleshooting; Specifications - Furrion CHILL FACR13LPSA-PS Manual De Usuario

TROUBLESHOOTING

Problem
Rooftop air conditioner constantly
switches itself off
Not cooling well
Water enters the vehicle
Rooftop air conditioner does not
switch on

SPECIFICATIONS

Cooling Capacity
EER (BTU/W)
Refrigerant
IP Class
Outdoor Sound Pressure Level
Roof Top Unit Dimensions
(W x H x D)
Volts/Frequency
Power Consumption (Cooling)
Cooling Amps
Cause
Freeze sensor has tripped.
The rooftop air conditioner is not set to
cooling.
The set temperature is too high.
The evaporator fan is damaged.
The condenser fan is damaged.
The air intake grilles are blocked or
obstructed.
The blower is defective.
The condensation water drainage
openings are clogged up.
The seals are damaged.
No supply voltage connected.
The voltage is too low.
Fuse blown or circuit protector tripped.
Outer temperature is too low or all air nozzles are closed.
Set the rooftop air conditioner to cooling.
Select a lower temperature.
Contact an authorized service agent or Furrion (see the detail contact info
at the back page of this manual).
Contact an authorized service agent or Furrion (see the detail contact info
at the back page of this manual).
Remove any leaves and other dirt from the ventilation grilles of the rooftop
air conditioner.
Contact an authorized service agent or Furrion (see the detail contact info
at the back page of this manual).
Clean the drainage openings for condensation water.
Contact an authorized service agent or Furrion (see the detail contact info
at the back page of this manual).
Check the power supply.
Contact an authorized service agent or Furrion (see the detail contact info
at the back page of this manual).
Check the electrical fuse of the power supply.
13500 BTU
9.78 (Cooling)
R410a
IP24
≤61dBA
29 1/16 x 10 15/16 x 41 9/16
ELECTRICAL
115V/60Hz
1380W
12.4A
- 12 -
Remedy
CCD-0007273 Rev: 11-04-22