Wire Connection - Digital Furrion Wall Controller/Thermostat; Electrical Shock Hazard - Furrion CHILL FACR13LPSA-PS Manual De Usuario

7. Stick the upper duct divider into the assembled mounting
frame.
NOTE: Make sure the upper duct divider is compressing
the top foam on the base of the air conditioner unit, and
compress tightly to the doubled sided tape on the lower
duct divider to ensure a positive retention.
Upper duct divider
8. Use self adhesive foil tape to seal the two halves of the
duct divider together and any potential gaps around the
duct divider to roof opening that may allow cold air to leak
back into the warm intake side.
NOTE: Clean metal surfaces to remove any oils to ensure
good adhesion of the foil tape.
Foil tape
9. Measure the height of the duct divider, and cut the PE foam
with a utility knife to the measured dimension. Peel paper
backer of foam to reveal sticky adhesive. Evenly adhere PE
condensation foam to duct divider, working material into
crevices and surfaces for a tight uniform fit across the duct
divider surface.
Duct Divider Height
PE Foam
Measured Duct
Divider Height
Wire Connection - Digital Furrion Wall
Controller/Thermostat

Electrical Shock Hazard

●
Disconnect power before servicing.
●
Provide grounding in compliance with all applicable
electrical codes.
Failure to obey this warning could result in death or serious injury.
1. Familiarize yourself with the ceiling controller and wire
harnesses.
NOTE: When connecting to a Furrion wall controller/
thermostat, the analog harness bundle is not used and can
be tucked away. The ends do not need to be capped or
taped.
Furnace Cable
(2-wires)
Wall Thermostat Cable
(4-wire harness)
LED Cable (1
white cable)
2. Loosen the strain relief and compartment cover of the
control box and pass the 115VAC power cord through
the strain relief hole and re-tighten the cable clamp until
properly restrained. Do not over tighten.
3. Make wire connections following the below color codes.
Black - Hot
White - Neutral
Green/yellow - Ground
4. Fit all cables into the cable compartment and tuck any
excess wires up out of the way. Tighten the cover with
screw.
- 8 -
DANGER
Freeze Sensor Cable (wire with
copper tip and blue plastic clip)
12V DC Power Cable
(2-wires)
Strain Relief
CCD-0007273 Rev: 11-04-22