Assembly Instructions; Installation Instructions Coc Sensor - Zehnder CO2 C55 Manual De Instalación

Always follow local safety regulations
during assembly of the device.
Check the device for damage caused by
transport.
Check that the mains voltage
corresponds to the local mains voltage.

3.2 Assembly instructions

Never install the CO
toilets or shower rooms. Excessive
humidity can damage the device.
Never place the CO
near large metal objects or devices
that transmit wireless signals or
cause electromagnetic interference
(EMI).
This may interfere with the signal
between the CO
ventilation unit.
Incorrect connection can damage
the operation.
Only use suitable tools to install
the CO Sensor.
2
Do not use a power tool to tighten
the screws.
Do not tighten screws too much.
Sensor in
2
Sensor RF
2
Sensor and the
2
Make sure that the device is not
covered so that the air quality can
be measured.
It is recommended to mounting the
CO Sensor between 1.0 and 1.5
2
metres above the floor so that it is
visible and easy to operate.
Do not mount the CO
higher than 2.0 metres from the
floor.
The CO Sensor only measures the
2
CO values of the room in which
2
the device is installed.
Always install the design cover (the
plastic cover).
3.3 Installation instructions CO
Sensor
The CO C Sensor must be
2
assigned to a zone. Eight sensors
can be assigned to each zone.
The CO C Sensor can only be
2
connected to a ventilation unit with
ComfoNet.
Sensor
2
C
2
EN - 35