BGS technic 7753 Manual De Instrucciones página 4

USE
1. Remove any retaining rings from the bearing (A) or the shaft (B).
2. Take the seperating shells (1) and place them on the bearing (A), the seperating shells (1) grip
around and under the bearing (A).
3. Connect the seperating shells (1) with the connecting bolts (2).
4. Now attach two of the bracket bolts (3) to the seperating shells (1).
5. Mount the puller bracket (5) on the bracket bolts (3) with the washers (7) and nuts (8).
6. Screw the thread adapter (9) into the puller bracket (5).
7. Turn the spindle (6) into the thread adapter (9) of the puller bracket (5).
8. Mount the pressure piece (10) on the lower end of the spindle (6).
9. Turn the spindle (6) by hand up to the shaft (B) from which the bearing (A) is to be withdrawn
and check again that the seperating unit is correctly seated.
10. Finally, turn the spindle (6) clockwise with a wrench until the bearing (A) is pulled off the shaft
(B).
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed