CARLO GAVAZZI PAM Manual Del Usuario página 6

Alignment output
Outputs (See indication during operation, yellow LED sensor
module)
Transistor output
The NPN or PNP output is a standard normally open (make switching)
output.
Alarm output (See indication during operation, red LED B. module)
The NPN or PNP alarm output is a normally open (make swiching)
output.
DIP switches (identical function for Channel A or B)
Gain 100% / 25%
ON
OFF
-
-
Gain settings
Manual: by turning the potentiometer away from minimum
position, the emitter power is regulated by the
potentiometer.
Automatic: by setting the potentiometer to minimum position, the
emitter power is regulated automatically when the "Auto
Adjust Input" is activated.
6
- the alignment output source is a 0 - 10 VDC
voltage reflecting the signal strength where 10
VDC is strong signal.
Description
- The setting of the channel can be
set to 100% by the gain overrule
input.
- The Gain overrule is disabled
ON Maximum emitter power is 100%
OFF Maximum emitter power is 25%