sunjoe SPX2100HH-SJG Manual Del Operador página 9

Using the Nozzles
Each nozzle has a different spray pattern. Determine the best
nozzle according to the cleaning task to be performed. This
electric pressure washer is equipped with two (2) nozzles that
easily snap onto the Quick-Connect collar of the stainless steel
lance.
m
CAUTION!
NEVER change nozzles without locking the
safety lock on the trigger handle.
m
WARNING!
High-pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
To connect a nozzle to the extension lance:
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release the water pressure.
2. Engage the safety lock on the trigger to prevent
unintentional start (Fig. 9).
Fig. 9
3. Pull back the collar and insert a desired nozzle. Release
the collar to lock the nozzle in place (Fig. 10).
Fig. 10
To disconnect a nozzle from the extension lance once the
cleaning job is complete:
4. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
5. Engage the safety lock on the trigger to lock the trigger.
6. Remove the nozzle by placing your hand over the nozzle
while pulling back on the Quick-Connect collar.
m
WARNING!
Do not make changes to the nozzle while
the trigger is engaged. Doing so could result in damage to the
pressure washer or injury to the user.
Working with Detergents
When cleaning with the pressure washer, some cleaning tasks
can be solved with water alone, but for most tasks cleaning
with detergent allows for more effective dirt removal.
For additional cleaning power, the unit comes equipped with a
detergent spray bottle with foam cannon.
m
WARNING!
Use only detergents specifically designed
for use with pressure washers, such as Sun Joe
DECK WASH (SPX-HDC1G), Sun Joe
WASH (SPX-FCS1G), or Sun Joe
(SPX-APC1G). DO NOT USE household detergents, acids,
alkaline solutions, bleaches, solvents, flammable material, or
industrial grade solutions. These could damage the pressure
washer. Many detergents may require mixing prior to use.
Prepare the cleaning solution as instructed on the solution
bottle.
1. Remove the foam cannon cap with detergent suction tube
from the bottle.
2. Fill the foam cannon bottle with detergent designed
specifically for use with pressure washers (Fig. 11).
Fig. 11
3. Recap the foam cannon, and attach it to the extension
lance by snapping it onto the Quick-Connect collar until it
clicks into place (Fig. 12).
Fig. 12
9
HOUSE +
®
SNOW FOAM AUTO
®
HEAVY DUTY CLEANER
®