VONROC CS505AC Traducción Del Manual Original página 9

Max. cutting capacity at 45°
- Rectangular
- L shape
- Circular
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardized test given in EN 62841; it may be
used to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-5.
1. Upper safety guard
2. Movable safety guard
3. Cutting disk
4. Spark deflector
5. Workpiece clamp
6. Handle grip
7a. On/Off switch
7b. Lock-off button
8. Carbon brush cover
9. Spindle lock button
10A. Depth stop bolt
10B. Depth stop nut
11. Transport lock pin
12. Workpiece rear clamp
13. Workpiece front clamp
14. Stopper lever
15. Workpiece spindle
16. Disk exchange wrench
17. Machine spindle
18. Big inner washer
19. Big outer washer
20. Small washer
21. Disk bolt
WWW.VONROC.COM
110mm x 102mm
110mm x 110mm
Ø 110mm
3. OPERATION
Before exchanging blades or adjusting the
machine, first remove the power plug from
the wall socket.
Removing the transport lock (Fig. B)
The machine has a transport lock pin (11) which
keeps its position low and makes it easy to trans-
port the device and store it. The lock button blocks
the up/down movement of the saw. And must be
de-activated before using the saw.
• Remove the transport lock by pushing the
machine down a little. While pushing down, the
transport lock pin (11) can be pulled out with
the other hand.
• After the pin (11) has been pulled out, the ma-
chine is able to move up and down freely.
Activating the transport lock (Fig. B)
• Push the machine down to its lowest position.
• Then push the transport lock pin (11) until it
slides in place.
Adding / removing a cutting disk (Fig. A, B, C)
Always remove the mains plug before
changing disks.
When changing disks always check related
safety instructions.
Removing a cutting disk
• Take the disk wrench (16) from the machine
base.
• Removing the disk is easier when the movable
safety guard (2) is moved up.
• Press the spindle lock button (9) in order to
block the movement of the machine spindle.
• Keep pressing the spindle lock button (9). Place
the wrench (16) on the disk bolt and turn it
slightly until the button (9) is pushed in to the
max and the spindle rotation is blocked.
• Remove the bolt (21), small washer (20), the
big outer washer (19).
• Then remove the cutting disk (3).
Mounting a cutting disk
• In case this has not been done yet, remove the
bolt (21) by turning it counterclockwise, then
remove small washer (20) and the big outer
washer (19).
EN
9