BSVILLAGE GALATEA SN-SAULO1 Manual Del Usuario página 26

IMPORTANT: Disconnect the cabin's power supply cable before undertaking any work.
Defaults
Indicator light for powersupply
not working
Indicator light for function is not
working
Infrared Heater not heating up
Odor from the sauna
26
MAINTENANCE
Possible reasons
The connector is not
connected properly
No power supply input
Indicator light is broken
The heating indicator light is
broken
The circuit board or compo-
nents are broken
The temperature sensor is
broken
The heater is broken
The wire junction or the hea-
ter's wire is loosen
The temperature sensor is
broken
The circuit board of the relay is
not work
The circuit's problems
Countermeasure
Check the connector or
replace a new one
Chick the circuity ( especially
weather there is power supply
input)
Replace the circuity panel
Please insert the antenna in
terminal or place the antenna
un open area
Replace the circuit board
Check if the connect is loosen
and replace it
Replace with a new one Of the
same specifications
Check and make them tight
Check if junction of the tempe-
rature sensor is loosen
and replace it
Replace the circuit board
1) There is eyewinker around,
remove it 2) Some heater's
temperature over high,cut off
the power supply,replace it. 3)
Parts on the circuity is broken