MaxPro PROFESSIONAL MPBMS255L Manual De Instrucciones página 10

10.Side support bar
11.Table fence
12.Bevel angle scale.
13.Bevel angle scale pointer.
14.Dust bag
15.On/Off Switch
16.Dust bag connector.
17.Locking bolt
18.Bevel lever handle
19.Rear support
20.Working clamp
21. Upper handle
22. Allen key
23. Saw shaft lock
24. Upper guard
25. Cover plate
1.Rear support ( Fig 1,2 )
The rear support (19) are under the base (6).
Deploy the rear support and (19) engage them correctly into the clips (19a) provided at the bottom plate of
the machine.
2.Working position.( Fig 3,4,5)
Lower the handle (1) and pull the locking bolt (17) out of its locking position.
-When the locking bolt (17) is unlocked, the handle (1) will lift automatic to the maximum upper position
Guide the handle while it lift to the upper position.
-After each job lock the machine in the transport position before store the machine.
Press the handle (1) slowly till it reach the lowest position, press the locking bolt (17) and slowly guide the
handle (1) in upwards direction till the lock by the locking bolt (17)
3.Support bar. (Fig 6+7)
-Loosen the locking bolts (10a) position on the base (6)
-Insert the end of the support (10) into the holes at the base (6)
Tighten the locking bolts (10a)
4.Install work piece clamp (Fig. 8)
The work piece clamp (20) can be mounted at both side of the base.
Note : If the mitre or bevel angle is adjusted and the motor housing will swing to the left side, you can
mount the work piece clamp at the right side.
-Loosen the locking bolts (20a) located at the support bar (20b)
-Insert the work piece clamp (20f) at the holes of the support bar (20b)
-If the work piece clamp is positioned correctly, tighten the locking bolts (20a)
5.Dust collection bag.(Fig 9 )
Squeeze the metal clamp (19a) at the dust collection bag (19) and move it over the dust connection (21)
6.Install of a stationary machine (Fig. 10)
This machine is used as a stationary machine only, Never use this machine as a mobile tool.
7
GB