GYS SMARTFEED M-4 Manual De Instrucciones página 17

DETERMINING THE FEEDER NUMBER
SMARTFEED wire feeders can be configured in «MASTER» or «SLAVE» mode.
In the case of two feeders, feeder no. 1 will be «MASTER» and feeder no. 2 will be «SLAVE».
The configuration is done via a DIP SWITCH (requires opening the product, see page 61-62).
ON ON ON
Master
1 2 1 2 1 2
If the configuration is not followed, the display of the HMI will show the
following error.
OPTIONAL CONNECTIVITY
The SMARTFEED M-4 / MB-PP wire feeders are equipped with a hatch on the front panel (I-5) that provides access to a 10-pin connector. This
connector allows the user to have additional inputs/outputs for automation functions.
Input/output terminal block markings (Top view):
1
The outputs are to be connected between terminals 1 to 5 and are arranged as follows:
- Terminal 1: 24 VDC power supply common to all outputs
- Terminal 2: Output no. 1
- Terminal 3: Output no. 2
- Terminal 4: Output no. 3
- Terminal 5: Output no. 4
The inputs are to be connected on terminals 6 to 10 and are arranged as follows:
- Terminal 6: Input no. 1 24VDC
- Terminal 7: Input no. 2 24VDC
- Terminal 8: Input no. 3 24VDC
- Terminal 9: Input no. 4 24VDC
- Terminal 10 : Ground 0 VDC common to all inputs
It is recommended to make the connection between the safety module and terminal block using a shielded cable.
Maximum wire cross-section will be 28-16AWG - 1.5mm².
Summary and technical characteristics of inputs and outputs:
Type of insulation
ON Voltage Vmin/Vmax
OFF Voltage Vmin/Vmax
Input impédance
Rated current at +24 V
SMARTFEED M-4 / MB-PP
ON
Slave
1 2
10
HARDWARE error
NODE : MMI
CODE : 0000
...
1.1
1.2
24V DO1
Output
Contact SEC 24V DC
1 - 24VDC
2-5 - DO1 – DO4 (NO)
+20V to +30 V
Max 2A
Diagram of terminal block:
1.3
1.4
DO2 DO3 DO4 DI1 DI2 DI3
Input
Photocoupler insulation 500 VDC
6-9 - DI1 – DI4 (NO)
10 - Ground (0V)
15VDC – 28VDC
0VDC – 5 VDC
800 KOhm
10 mA
EN
DI4 MASS
17