VONROC WS501AC Traducción Del Manual Original página 8

EN
• Always place the steam plate (6) in a suitable
container when left unattended, even for a few
seconds, and keep the steam plate facing away
from you when in use (fig. H).
Storage
• Allow the appliance to cool for at least 10 minu-
tes.
• Before storing, ensure that all water has been
emptied from the water tank and dry it with a
cloth.
• Store the appliance upright in a dry place.
Safety cut out
A safety cut out is fitted to prevent overheating
the element if the water level is low. If unit stops
boiling during use this may be the cause. Wait for 2
minutes before removing the filling cap then re-fill
with clean tap water. The cut-out will self-reset and
steam be produced again within 5-25 minutes.
The cut-out will not protect the element if a partly
filled unit is tilted during use in a way which ena-
bles part of the element to be out of the water for
longer than 15-20 seconds.
5. MAINTENANCE
Warning! Before performing any maintenan-
ce, switch off and unplug the appliance and
allow it to cool. Occasionally rinse the boiler
with tap water until it runs clear.
Do not use chemical additives.
This appliance/tool has been designed to operate
over a long period of time with a minimum of main-
tenance. Continuous satisfactory operation de-
pends upon proper tool care and regular cleaning.
TROUBLE SHOOTING
Unit fails to boil
The unit had probably not been left for long enough
to cool- refer to section on safety cut out. Check
the fuse in the plug is sound and rated at 13 amps.
If using an extension cord check that it is rated at a
minimum of 10 amps and fully unwound.
Unit leaks steam from pressure relief valve
The pressure relief valve is a special low pressure
valve and cannot be replaced by any other valve. If
steam is leaking form the valve, the most likely cau-
8
se is a blockage in the hose. Allow the hose to cool
then remove the hose and check for any blockage.
Always check the inlet in the tool you are using.
Under no circumstance force the valve shut.
This is operating for your protection.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
plied warranties of merchantability and fitness for
a particular purpose. In no event shall VONROC be
liable for any incidental or consequential damages.
The dealers remedies shall be limited to repair or
replacement of nonconforming units or parts.
WWW.VONROC.COM