Connection Check List - Alpine HDA-M80 Manual De Operación

e

CONNECTION CHECK LIST

ded) to
Please check your head unit for the conditions
nsulated
listed below:
ire
Remote Turn-On Lead
a. The head unit does not have a remote turn-on
or power antenna lead.
b. The head unit's power antenna lead is activated
only when the radio is on (turns off in the tape
or CD Mode).
c. The head unit's power antenna lead is logic level
ry Lead
output (+) 5V, negative trigger (grounding type),
or cannot sustain (+) 12V when connected to
other equipment in addition to the vehicle's
power antenna.
If any of the above conditions exist, the remote
n On Lead
turn-on lead of your HDA-M80/HDA-F60/
HDA-V90 must be connected to a switched
power source (ignition) in the vehicle. Be sure to
use a 3A fuse as close as possible to this ignition
tap. Using this connection method, the
HDA-M80/HDA-F60/HDA-V90 will turn on and
stay on as long as the ignition switch is on.
ector
If this is objectionable, a SPST (Single Pole,
Single Throw) switch, in addition to the 3A fuse
mentioned above, may be installed in-line on
the HDA-M80/HDA-F60/HDA-V90 turn-on lead.
This switch will then be used to turn on (and off )
the HDA-M80/HDA-F60/HDA-V90. Therefore, the
switch should be mounted so that is accessible
by the driver. Make sure the switch is turned off
when the vehicle is not running. Otherwise, the
amplifier will remain on and drain the battery.
(+)
tached
nector.
ads last.
ng to
ALPINE HDA-M80/HDA-F60/HDA-V90 68-44781Z25-A (EN/DE/FR/ES/IT/SE/RU/CS)
Blue/White
Power Antenna
Remote Turn-On Lead
To other Alpine component's Remote Turn-On
Leads
SPST Switch (optional)
Fuse (3A)
As close as possible to the vehicle's ignition tap
Ignition Source
Amplifier
EN
DE
FR
ES
IT
SE
RU
CS
7
-EN