Using The Lcd Monitor; Switching On The Monitor - Dometic M75LX AHD Instrucciones De Montaje

Using the LCD monitor

Observe the following instructions when laying the connection cable:
• If possible, use original ducts for laying the cables, or other suitable options, such as ventilation
grilles. If there are no existing ducts, you must drill a hole of  22 mm. Check beforehand that
there is sufficient space on the other side for the drill head to emerge (fig. 2, page 4).
• Cover the holes with the feed through in the base of the monitor bracket.
• To prevent damage to the cables, when laying them ensure that there is always sufficient dis-
tance to vehicle components which can become hot (lights, heaters, ventilators etc.).
• When laying the cables (fig. 3, page 4), make sure:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection.
Connecting the monitor (fig. b, page 7)
➤ Lay the connection cable for the monitor bracket on the dashboard.
➤ Insert the plug of the monitor cable (2) into the socket (4) of the connection cable (3).
Wait until you hear the plug snap in.
A
NOTICE! Beware of damage
Make sure the polarity is correct when connecting to a voltage source.
This version of M75LX AHD is prepared to be operated with a customized power cord especially
designed to operate the turn assistant camera CAM1000/ BSC01. The standard power cord pro-
viding 4 camera inputs and trigger wires to activate the rear/ side view cameras can be ordered as
accessory if needed. The power cord in this package is equipped wit a 6 p TE connector. It pro-
vides 6 single wires 1 - 6. The color/ function assignment is:
6-pin socket 1 = red on ignition; 3 = black on ground; 2 = white, left turn signal; 4 = green, right
turn signal; 5 = not used; 6 = green reverse gear
7 Using the LCD monitor
I
NOTE
In combination with CAM1000/ BSC01 the operation of the monitor is inactive to pre-
vent accidental switching off etc.!
7.1

Switching on the monitor

➤ If the monitor is switched off, press the P button (fig. 0 2, page 6) to switch the monitor on.
➤ The button lights up green.
✓ The picture appears.
16
M75LX AHD
EN