Bosch NGM8048UC Instrucciones De Instalación página 16

en-us Conversion to LP gas
For model NGM8048UC:
4.
Tilt up the maintop from the front
‒
grounding connection . Then lift off the main top
from the cooktop ⁠ .
For model NGM8648UC:
5.
Lift up the maintop at the rear
‒
front to disengage the fastening clips at the front .
Lower the rear side of the maintop and tilt up the
maintop from the front . Unplug the grounding con-
nection . Then lift off the main top from the
cooktop ⁠ .
1
16
and unplug the
and pull it toward the
2
Remove the electronics pack from the control panel:
6.
With a flat head screwdriver carefully pry the black
‒
tabs at the front away from the panel one by one,
while lifting up the transparent cover of the electron-
ics pack to disengage the tabs.
When all tabs are unlocked you can lift off the elec-
‒
tronics pack.
3
2
1
Remove the black disks from the valve stems. Make
7.
sure the springs underneath the black disks do not
come off.
Adjust the black T10 star head setting screw with a T10
8.
star head screwdriver. Refer to the burner chart for the
correct setting of the setting screws (M).
→ "Burner chart", Page 17
Use setting for LP Gas. The setting screws must
‒
be tightened properly.
Use setting for natural gas. The setting screws
‒
must finish flush with the fitting.
The dual-flame burner has 2 setting screws.
Replace the white disks and the electronics pack.
9.
Ensure that the gaskets around the burner bases are in
10.
place.