Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation over oven
A
min. ¾" (19 mm)
max. 2" (50 mm)
B
5⅞" (150 mm)
C
2¾" (70 mm)
D
Refer to Approved Combination Matrix
E
2⅜" (60)
Installation with horizontal panel
If there is no oven beneath the cooktop, install a horizontal
panel. To allow access to the power supply connection
and regulator maintain a minimum clearance of
⅜" (10 mm) from the edges of the panel (F).
IMPORTANT: Complete the installation of the cooktop be-
fore installing the horizontal panel.
Installation above a drawer
A
min. ¾" (19 mm)
max. 2" (50 mm)
B
5⅞" (150 mm)
C
2¾" (70 mm)
D
min. 0" (0 mm)
E
2⅜" (60)
F
min. ⅜" (10 mm)
Installation above a cabinet door
A
min. ¾" (19 mm)
max. 2" (50 mm)
B
5⅞" (150 mm)
C
2¾" (70 mm)
D
min. 0" (0 mm)
E
2⅜" (60)
F
min. ⅜" (10 mm)
G
min. 1" (25)
4 Installation procedure
Installation procedure
Follow these instructions to install the cooktop into the
Installation procedure
countertop.
CAUTION
Sharp edges.
Use protective gloves when installing the appliance.
▶
CAUTION
The appliance is heavy.
It is recommended that two people install this appliance.
▶
4.1 Preparing the cooktop
Note: For NGM8648UC: If the appliance is to be used
with LP gas, carry out the LP gas conversion BEFORE in-
stalling the appliance in the countertop.
→ "Conversion to LP gas", Page 14
Place the cooktop face down on a soft and stable sur-
1.
face. Use the foam sheet from the packaging to protect
surfaces from scratching.
Installation procedure en-us
9
Publicidad
Tabla de contenido
