Wellell Optima Auto Manual Del Usuario página 12

Optima Auto Series / English
(4). Plug the power cord into electrical outlet.
NOTE- Make sure the pump unit is suitable for the local power voltage.
NOTE- The plug is also served to stop the device.
NOTE- Pump might still be in operation after the power cord disconnection if optional battery
is built-in.
(5). Turn the power switch to ON position.
CAUTION- The pump can only be applied to the mattress recommended by the manufacturer.
Do not use it for any other purpose. (Applied part: air mattress) Do not position the equipment
so that it is difficult to operate the disconnecting device.
CAUTION- Allow the mattress to inflate before positioning the patient on the mattress.
(6). The cable management tape is provided along the side of the mattress to manage power cord. Please
make sure the wire has no signs of damage. After installation, extra length of the power cord, if any,
should be neatly managed to prevent stumble accident and should be clear of moving bed
mechanisms or other possible entrapment areas.
NOTE- The EQUIPMENT should be firmly placed at position where users can easily access to.
3.2. Position Sensor- installation & removal
Position sensor is key to auto seat inflation. It allows the mattress
automatically to inflate when the head section has been raised to prevent
bottoming out.
To initiate this function, you should connect the sensor cord to the unit.
To
(1). Align the arrows on the cord and the unit.
Attach
(2). Insert the cord accordingly as illustrated.
(1). Put your fingers at the end of the cord as illustrated.
(2). Pull backward to detach it from the unit.
Detach
Note: The grey area is the protection mechanism that
prevents misuse and enables a proper detachment by
sliding it backward.
Warning: Do not immerse in water.
Steps
9
Illustration