Chimney Requirements - Master Forge WS110 Instrucciones De Funcionamiento Y Manual Del Propietario

• The joints of any and all connections for both of
ventilation systems (the inlet air and the combustion
exhaust) must be sealed with high temperature
silicone.
• The chimney must comply with all applicable
codes and requirements of the authority having
jurisdiction.
• The chimney must be removed for any mobile home
transportation, and reinstalled per all instructions
after transportation.

CHIMNEY REQUIREMENTS

GENERAL
CAUTION: DO NOT USE MAKESHIFT
COMPROMISES WHEN INSTALLING THE
VENTING SYSTEM; HAVE EXISTING CHIMNEY
SYSTEMS INSPECTED BEFORE USE AND
BE CERTAIN ALL NEW CHIMNEY SYSTEMS
ARE INSTALLED TO THE MANUFACTURER'S
SPECIFICATIONS AND WITH ONLY UL LISTED
COMPONENTS (ULC IF CANADA).
For the sake of exhausting combustion products
and also establishing a draft which provides oxygen
for combustion, the stove must be installed for use
in conjunction with one of the following approved
chimney systems:
• A chimney complying with the requirements for
Type HT (2100˚F) chimneys in the Standard for
Chimneys, Factory-Built, Residential Type and
Building Heating Appliance, UL 103 or ULC S629 or
a code-approved masonry chimney with a flue liner.
• The chimney size should not be less than or more
than three times greater than the cross-sectional
area of the flue collar.
• An existing fireplace that is structurally sound,
incorporates flue liner (clay tile which protects
chimney), has its damper closed and sealed, and
has been approved for conversion by a qualified
expert.
Any/All chimney systems:
• Must meet the following minimum requirements:
— Be at least 15 feet (4.6 m) tall, measured from the
top of the stove to the tip of the chimney cap
— Must be at least 3 feet above the roof, measured
from the highest point of contact with the roof
and the tip of the chimney cap.
— Must be at least 2 feet (61 cm) above the highest
point of the slope of the roof within 10 feet (305
cm) horizontally.
• Must have a negative pressure of 0.05 to 0.06 inches
water column to create an appropriate draft.
• Must not be stove pipe material. Instead, only the
three structures specified above may be used.
Master Forge Wood Fire Stove
• Must not be installed for the purposes of venting a
cellar or basement.
• Must not be used for this stove if it also serves any
other appliance.
• Must not be obstructed by the chimney connector
pipes, such as the Figure
Contact your local building authority for approved
methods of installation and any necessary permits and/
or inspections.
Correct
Figure 10 Connection Pipe & Chimney Connection
LINED MASONRY CHIMNEY INSTRUCTIONS &
DIAGRAM
This stove is designed to be vented through a masonry
chimney with flue liner (clay tile which protects
chimney) which conforms to local building codes, fire
codes, and latest edition of NFPA 211 US or CAN/
CSA-B365.
1. Clean the code-approved lined masonry chimney
2. Inspect the lining of the chimney and make any
required repairs.
3. If the connection piping from the stove to a
masonry chimney is made through a combustible
wall, consult a qualified mason or chimney dealer
for consultation. To ensure safety, the installation
should only be done by a qualified installer. The
installation must conform to the regulations
established by local fire codes and building codes.
THIMBLE
COLLAR
6" ROUND
24 ga. BLACK
CONNECTOR
STOVEPIPE
LINER
BELOW
ENTRY
Figure 11 Connection to Masonry Chimney
E10
Operating Instructions and Owner's Manual
10 below illustrates.
Wrong Wrong
CHIMNEY
FLUE
5/8" TILE
CHIMNEY
LINER
MASONRY
CHIMNEY
HOLE