Master Forge WS110 Instrucciones De Funcionamiento Y Manual Del Propietario página 16

HIGH FIRE WITH A COLD START
To start the fire from a "cold" stove:
1. Inspect that all seals on the door, ash drawer, and
ash plug are in good condition. Close the ash
drawer. Plug ash hole. Inspect the chimney and
chimney connector, see maintenance on page 18.
CAUTION: DO NOT OPERATE STOVE IF THE
GLASS IS BROKEN.
WARNING: THE CHIMNEY CONNECTOR
MUST BE IN GOOD CONDITION AND BE
KEPT CLEAN TO SAFELY USE THIS STOVE.
2. Cut and split approximately 15 kindling pieces 16
inches long. Half of them should be approximately
3/4 inch square, the rest 1/2 inch square. The
kindling should be very dry and weigh approximately
4.5 lbs.
WARNING: DO NOT USE GRATE OR
ELEVATE FIRE – BUILD WOOD FIRE
DIRECTLY ON HEARTH. DO NOT
OPERATE WITH THE MAIN DOOR OPEN –
OPERATING THE STOVE WITH THE MAIN
DOOR OPEN WILL CREATE AN OVER-FIRE.
3. Cut and split approximately 15 start-up fuel pieces
16 inches long. Half of the pieces should be larger
cross-section (approximately 1 ½ inches square) and
the rest smaller cross-section (approximately 1 inch's
square). These can be split from larger fuel pieces
that are in the range of 19-25% moisture (Dry-basis).
The total weight of the start-up fuel should be
approximately 6.8 lbs.
CAUTION: WHEN TENDING THE STOVE
ALWAYS WEAR FIRE RETARDANT CLOTHING
AND PROTECTIVE EYEWARE.
4. Arrange the start-up fuel pieces in a grid as shown
in the following Figures. Place two of the larger
pieces about six inches apart going front to back.
Next, two more pieces the same size left to right
about six inches apart. Place about seven of the
small pieces front to back on top of the gird. See
Figure 18. Place the remaining start up fuel sideways
on top.
Master Forge Wood Fire Stove
Figure 18 Start Up Fuel
5. Next arrange the kindling pieces in a similar
alternation grid pattern with the larger pieces first
followed by the smallest with a layer of three pieces
going left to right as shown with six or seven pieces
on the top. See Figure 19.
Figure 19
Start up fuel and kindling on top, start up fuel on
the bottom, stacked in the fire box from largest cross-
section on the bottom to smallest on the top.
WARNING: NEVER LEAVE A RUNNING STOVE
UNATTENDED WHILE DOOR IS OPEN.
THE DOOR MAY ONLY BE OPEN FOR FIRE
STARTING AND FIRE TENDING. TO CLOSE:
FIRMLY ROTATE DOOR HANDLE CLOCK WISE
UNTIL THE DOOR IS SECURELY LATCHED. DO
NOT SLAM THE DOOR.
6. To start make sure the air control is pulled all the
way out.
7. Using a propane torch, light the top front of the
kindling grid. The torch should be operated for 60
seconds.
E16
Operating Instructions and Owner's Manual