Cleaningand Maintenance; Safety Instructions; Daily Maintenance - Casselin CVR40L Manual De Instrucciones

- In order to avoid damaging the compressor, the appliance must not be tilted
more than 45° during transport or installation.
- Leave the appliance to rest for 2 hours before using it for the first time.
- Before use, the device must be cleaned
- Connect the device and press the ON button, choose the desired temperature. Do not put the drinks until
the desired temperature has been obtained.
- LCD indicator: the indicator lamp is on during the cooling phase and remains off as long as the temperature
of the refrigeration chamber is stable and flashes when the compressor remains off for too long.
- LCD defrost indicator: the appliance is equipped with an automatic defrost which is activated 4 times over
24 hours. The pilot light comes on during the defrost phase and goes off when the defrost is finished. It
flashes when the appliance has not been defrosted for a long time.
- Manual defrosting is also possible if the efficiency of the refrigeration decreases, as for example during an
untimely opening.
- Any hot dish must be cooled before inserting it into the appliance.
- The height of the shelves must be adapted to the height of the dishes. Dishes should be properly spaced
to maximize the effect of refrigeration.
WARNING !
The compressor can reach a high temperature. It is forbidden to touch the surface of the compressor
when the device is in operation or immediately after use in order to avoid any risk of injury!
6. CLEANING AND MAINTENANCE

6.1 Safety instructions

Any maintenance, cleaning, repair of the appliance must be done with the appliance unplugged (isolated from
all electrical sources).
The use of caustic detergents and baking soda for cleaning is prohibited. Water must not get inside the
device.
Never immerse the appliance in water or any other liquid.
Use the Casselin brand products provided for this purpose.
WARNING
The device cannot be cleaned with a direct water jet (no pressurized water jet).

6.2 Daily maintenance

- Clean the device regularly
- Remove the shelves and clean them with a soft product and a clean cloth.
- Clean the interior with a lukewarm cloth and a specific cleaning product
- Rinse with clear water
- Use a soft, dry cloth to polish the surfaces.
- After cleaning, use a soft, dry cloth to polish and dry the device.
- Leave the doors open and let the appliance dry
- If the showcase is not used, store the appliance in a dry place.
6.3 Safety instructions for the maintenance of the device
Daily check that the power cord is not damaged. Never use the appliance when the cord is damaged. If the
cord has any faults, it must be replaced by a qualified technician.
In the event of a fault, contact your dealer.
Any maintenance or repair work should only be carried out by a professional.
EN