Cleaningand Maintenance; Safety Instructions; Daily Maintenance - Casselin CPAST480 Manual De Instrucciones

out. When the temperature decreases, the device starts heating again and the green light turns on again
until the correct temperature is reached. If you are not using the appliance, turn off the thermostat, turn
off the On/Off switch and unplug the appliance.
REMARK
The appliance is equipped with a safety system in case of overheating. In case of tripping, disconnect
appliance and let it cool down. If this protection system activates regularly, it is
imperative to contact our after-sales service or your retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the
back of the device. To do this, wait for the oil temperature to drop, then unscrew the protection
plastic by turning anti-clockwise, press the reset button then
screw the plastic protection back on.
6. CLEANING AND MAINTENANCE

6.1 Safety instructions

Any maintenance, cleaning, repair of the appliance must be done with the appliance unplugged (isolated from
all electrical sources).
The use of caustic detergents and baking soda for cleaning is prohibited. Water must not get inside the
device.
Never immerse the appliance in water or any other liquid.
Use the Casselin brand products provided for this purpose.
WARNING
The device cannot be cleaned with a direct water jet (no pressurized water jet).

6.2 Daily maintenance

Unplug the device
Let the device cool down
Clean the appliance after each use, including the grease collection tray.
Clean the device with warm water and a clean cloth after each use.
After cleaning, use a soft, dry cloth to polish and dry the device. All parts must
be dried.
Never use hard or abrasive material that could scratch the device and damage it. Do not use
of chlorine or derivative solution.
After each cleaning apply a vegetable oil on the surface of the plate.
Store the device in a dry place.
6.3 Safety instructions for the maintenance of the device
Daily check that the power cord is not damaged. Never use the appliance when the cord is damaged. If the
cord has any faults, it must be replaced by a qualified technician.
In the event of a fault, contact your dealer.
Any maintenance or repair work should only be carried out by a professional.
REMARK
In the event of a trip, unplug the appliance, let it cool down and contact your retailer. If the unit does not start,
check your power cord. The device must not be plugged into a power strip but directly into a wall socket. For
any other anomaly, contact your dealer.
REMARK
Waste from used devices: all used devices must, when disposed of, comply with the regulations in force in
their country*. It is imperative to make the device unusable before disposal by removing the power supply
cable.
* in terms of ecology and recycling
EN