Use; Cleaningand Maintenance; Safety Instructions - Casselin CACM Manual De Instrucciones

• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.

5.2 Use

WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The device must be completely removed from its packaging. All guards must be completely removed.
Place the unit upright on a sturdy, flat surface. Never place the device on a flammable surface.
Do not install this device near open fires or other heating devices.
It is forbidden to place flammable objects on the device or within a distance of less than 10 cm from the
device.
The electrical cable must be protected to at least 16 amps.
The device must be plugged directly into a wall outlet.
Using a power strip will trip the device.
USE
Fill the device with the desired quantity of plates.
Connect the device. Press the switch.
Set the appliance using the thermostat knob to the desired temperature.
The set temperature is between 60 and 80°C and the device takes about 20-25 minutes to reach it.
To turn off the appliance, set the thermostat to position "0".
Always unplug the device when the device is not in use.
REMARK
The appliance is equipped with a safety system in case of overheating. In the event of tripping, unplug the
appliance and allow it to cool. If this protection system activates regularly, it is essential to contact your
retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device. To do this, wait for the temperature to drop, press the Reset button.
6. CLEANING AND MAINTENANCE

6.1 Safety instructions

EN