Digital Temperature Controller; Installation And Use; Safety Instructions - Casselin CVG413 Manual De Instrucciones

Digital temperature controller:

- The regulator is located at the back of the device
- There are two keys to lower or raise the temperature
- The first liquid crystal indicator corresponds to the compressor, lit when the compressor is running for
cooling
- The second liquid crystal indicator corresponds to the defrost, lit when the automatic defrost is on
- This key corresponds to the LED lighting
1. Adjust the temperature: Press the button
Where to modify and store the displayed value. Push the button
display the cold room temperature.
2. If you do not press any other button within 10 seconds, the temperature of the cold room is
displayed.
3. Lighting: Press the button
Press the button
4. Refrigeration LED: During refrigeration, the light is on; When the cold room temperature is
constant, the light is off; During delayed start, the light flashes.
5. Defrost LED: during defrost, the LED is on; when defrosting stops, the LED is off. During the
delayed defrost display, the LED flashes.
6. Digital Controller Reset
When the screen displays "disorder", press the button for 2 seconds until the beep sounds, quickly press
the button for 6 seconds until the beep sounds again, the screen flashes for 3 seconds and restores
factory settings.

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into an appliance that is in operation or still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
, it lights up; press again, it stops. Manual defrost with stop/start:
and hold for 6 seconds to defrost or stop defrost.
, the set temperature is displayed. Push the button
to exit the setting and
EN