Hkoenig oly900 Manual De Instrucciones página 9

5. Clean the outer element with the brush and make sure there is no
residue inside.
6. Fix the extrusion shaft and then the outer element when you
assemble the machine.
TROUBLESHOOTING
NO. PROBLEM:
Screw extrusion shaft got
1
stuck
Motor stops rotating and
2
doesn't squeeze oil
Leakage prevention board
SOLUTIONS:
A: Press the "reverse" button for 5 seconds and the
extrusion shaft will reverse back the ingredients. Then
press "Start/Pause" button.
B: Turn off and pull out the plug. Disassemble the out
element and extrusion shaft, clean the items as well as
the hopper and its entrance. Assemble it back!
A: It is normal for the motor to take 30-45 seconds to
preheat the extrusion shaft before it starts squeezing.
B: Check if the hopper lid or oil box are in the correct
position.