Treadmill Tightening - SPORTSTECH FX3 Pro Manual De Instrucciones

ADJUSTING THE TIGHTNESS
The treadmill is pre-assembled at the factory and set correctly.
After the initial installation / assembly at home or after a certain period of use, the rotating treadmill can become loose.
The tightness decreases. Signs of this can be e.g. a sudden pause of the device while running or a slipping of the
rotating treadmill. If you notice these signs with your device, please proceed as follows:
Use the supplied hex key for this.
To tighten the treadmill:
1. Turn the left screw for treadmill tension (See Figure 4: Connections and controls / at the front end of the
device).
2. ½ turn counter clockwise
3. Then turn the right adjusting screw for treadmill tension (See Figure 4: Connections and controls / at the front
end of the device).
4. ½ turn counterclockwise.
IMPORTANT:
• A treadmill that is set too loose can slip very easily and represents a considerable risk of accident.
• A treadmill that is tightened too much places a heavy load on the motor and mechanical components and
can, among other things, lead to engine damage.

TREADMILL TIGHTENING

41
Set screws
for treadmill tension
EN