Safety Instructions; Target Group; Intended Use - Dometic SP230 Instrucciones De Uso

3 Safety instructions

WARNING! Electrocution hazard, Fire hazard
• Installation, assembly, and wiring as well as all other work may only be performed by qualified electri-
cal specialists. Inadequate repairs may cause serious hazards.
• Installation in potentially explosive areas such as rooms with flammable liquids or gases is not permit-
ted.
• Do not install or keep the device near naked flames or other heat sources (heating, direct sunlight, gas
ovens etc.).
• Always install and keep the device out of the reach of children.
NOTICE! Damage hazard
• Check that the voltage specification on the data plate corresponds to that of the energy supply.
• Never immerse the device in water.
• Protect the device and cables against heat and moisture.
• Do not expose the device to rain.

4 Target Group

The electrical power supply must be connected by a qualified electrician who has demonstrated skill and
knowledge related to the construction and operation of electrical equipment and installations, and who
is familiar with the applicable regulations of the country in which the equipment is to be installed and/or
used, and has received safety training to identify and avoid the hazards involved.

5 Intended use

The priority switch is intended for distributing power supply in recreational vehicles (RV) with two available voltage
supplies.
Two outputs are available:
• Electrical appliances that are used only when mains from grid is available.
• Electrical appliances that can be powered by both mains from grid and battery via an inverter.
The priority switch can be used according to the specified protection type after proper installation and cable routing
with suitable cable diameters and external strain relief. The device is not suitable for outdoor use.
This product is only suitable for the intended purpose and application in accordance with these instructions.
This manual provides information that is necessary for proper installation and/or operation of the product. Poor in-
stallation and/or improper operating or maintenance will result in unsatisfactory performance and a possible failure.
The manufacturer accepts no liability for any injury or damage to the product resulting from:
• Incorrect assembly or connection, including excess voltage
• Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in this manual
EN
5